Table is around 31" high x 29" deep x 5ft long. It can hold an impressive amount of weight for the design. I estimate at one point it had about 300 lbs of dimensioned doug fir on it when I was using it to build my current work bench. Rolls around nicely on heavy duty locking casters. The person before me used it as a router table. I dropped in a piece of plexiglass temporarily to cover the router lift mounting hole. Top is held down by 4 to 6 bolts from underneath and I'll have to remove it to get it out of its current location. Minor logistical timing for pickup so will need to work with you to schedule pick up. Make offer.

One 18" × 24" × 3" machinist/metrology inspection plate. Two are shown in the photo. Surface appears very clean with no obvious chips or damage. I do not have current calibration certification, so it is being sold as an uncertified surface plate. Approximately 150 lb. Local pickup - they are deceptively heavy! $350 OBO.

18" x 6" x 2" precision surface plate. I picked this up at the local Rockler store around 3 years ago now. It's redundant since I have the larger one. $30

Free items

Various older planes that were given to me but don't have time to get them into working condition. 

Buck and coping saw

Old timer drill brace - I don't have drill bits for it.

Text please if interested - 520 603 1804. Will likely respond afternoons/evenings.